Read the forum code of contact
By: - 26th June 2015 at 13:25 Permalink - Edited 1st January 1970 at 01:00
If anyone has one
Don't think I've got one John but I've got a picture of one which might help? (or at least this is what it looks like to me).
[ATTACH=CONFIG]238663[/ATTACH]
By: - 26th June 2015 at 14:06 Permalink - Edited 1st January 1970 at 01:00
Thanks Alan
Thinking about it I remember seeing that in a Brown Bros catalogue, so it looks like the request should be for an AGS591 rod end then, type immaterial although preferable a 'S' or 'CS'
cheers
John
By: - 26th June 2015 at 15:24 Permalink - Edited 1st January 1970 at 01:00
Shame I have some old ones that are US thread sizes, I even have some female ended ones that you could trim down the remaining thread portion on and then screw it to it, but if on view it wouldn't look right.
By: - 26th June 2015 at 18:03 Permalink - Edited 1st January 1970 at 01:00
Hi Tony
That's a pity, but thanks for looking for us:D
John
By: - 29th June 2015 at 09:46 Permalink - Edited 1st January 1970 at 01:00
I did see this
By: - 29th June 2015 at 10:05 Permalink - Edited 1st January 1970 at 01:00
Thanks Tony, that has UNF threads unfortunately
John
By: - 29th June 2015 at 12:30 Permalink - Edited 1st January 1970 at 01:00
My **** up, I posted the wrong link....
though i think the shank is to small
By: - 29th June 2015 at 14:19 Permalink - Edited 1st January 1970 at 01:00
No probs, I ahem bought some of those in error; the shank is too small...doh!
Posts: 1,952
By: 12jaguar - 26th June 2015 at 12:17
Hi all
We're on the scrounge (again) for a rod end bearing as per the attached photo which is off the Landing lamp lever actuating rod. one of the bearings is completely shot (broken off on impact) and the other is badly damaged but just about workable. If anyone has one or possibly two 5/16" BSF RH thread rod ends with a 2BA (3/16") bearing bore (5/16" would be acceptable as can be sleeved) we'd be very grateful.
TIA John
[ATTACH=CONFIG]238662[/ATTACH]